DIN / – Now renamed EN / Not batch specific; Gives average values for that material from that mill over a period. ~ DIN / B – Now. inspection specifications of DIN Part 5 (see pages /5) usually Because the German standard DIN is well-known and is cited in many. Buy DIN () Metallic Products; Types Of Inspection Documents from SAI Global.
|Published (Last):||23 February 2012|
|PDF File Size:||9.16 Mb|
|ePub File Size:||4.8 Mb|
|Price:||Free* [*Free Regsitration Required]|
ZC – Test report EN (corresponds to DIN ) – ifm electronic
In Germany cin documents certificate types were originally specified in standard DIN The definitions of material testing and certificate types in DIN was adopted for European standard ENfirst published in EN was revised in and published as BSEN in October with a simplified range of inspection documents certificate types.
These now only include types 2.
This reduced range of options should be easier to understand and work with. When this standard and certificate type is shown, it only refers to the certificate type and not the steel standard.
This should be covered separately eg BSENfor stainless steel sheet or plate type products. Each of the certificate types has a reference number, which has both its content and ‘validation’ requirements described in the standard in Appendix A, Table A.
These descriptions are sometimes a little difficult to interpret and need some additional interpretation. The table below shows the full range of current C and withdrawn W EN certificate types, with some interpretation of what they cover. In any case of dispute however the descriptions given in Table A.
Office and Postal Address: BSEN test certificates for stainless steel products Introduction In Germany inspection documents certificate types were originally specified in standard DIN This should be covered separately eg BSENfor stainless steel sheet or plate type products Test certificate standards and types Each of the certificate types has a reference number, which has both its content and ‘validation’ requirements described in the standard in Appendix A, Table A.
No test results shown.
Like the old BS ‘Cast Test’ certificate. Mechanical test sample results from another coil from same cast, manufactured by the same process route, can be used.
Difficult to distinguish this from the 3. Common certificate type issued for ‘batch tested’ material. This cover what is often referred to as ‘outside inspection’.
Statement of compliance with the order by the manufacturer based on non-specific inspections tests by the manufacturer.